Programmable ignition for 1974 Suzuki 750 GT water cooled two stroke. Replaces breaker points system.

SET Includes:

• 1 x TCIP4 with pre-programmed ignition curve for Suzuki 750 GT
• 1 x Loose wire connector loom
• 1 x Base Plate
• 1 x Rotor (shown in the photo at 10° BTDC)
• 1 x Pickup IP6

This unit requires a 12 V DC battery. It will operate using the original coils from the points system or Ignitech Coil IC-TCI-S.

Recommended accessories:

USB-Com Cable to connect to PC Computer

Com-Com Cable extension 5metres

This Ignitec SPARKER TCIP4 ignition is equipped with 4 x inputs for pickup. Suitable for 4 cylinder, 120 Degree 3, and 6 cylinders engines or where more than two inputs is desirable.

Input for throttle position sensor or inlet air pressure sensor, two multifunctional switch inputs for blocking, kill switch, retard etc. output for tachometer, two multifunction switch outputs for fuel pump relay, gear shift light etc

This Ignition is fully programmable using Computer Software. Software control includes advance map or curve, options for blocking, rev limiter etc.

A free download is available for the 8 page Owners Manual

5K Ohm Resistor plug caps or 'R' type spark plugs (but not both together) are required to avoid damage to the Ignition unit.