Electrical

73 HTC1 Heat Transfer Compound 75g

MCSHTC1 HEAT TRANSFER SILICON COMPOUND. 10gm heat transfer compound.Ideal for assisting heat transfer between semiconductors and their heatsinks.Handy tube.Silicone based compound for maintaining a...

73103016 Diode with spade terminals

Diode with spade terminal connection. A one-way electrical connection between the battery and generator Suits Laverda 750 and early 1000 models and other motorcycles fitted with a generator

77110020 Stator/Generator Plate RGS/S2 XG02

Electrex G2 Stator Plate for Laverda RGS 1000 and Series 2 1000 Models. MPORTANT: Measure your original and compare the dimensions below before you order.Outer Diameter: Ø102mm     Inner diameter:...

93-BCT-0242 Dr Smart Charger For 6 & 12V Batteries

CYK93-BCT-0242     DR Smart Battery Charger for 6V and 12V DC Lead Acid Battery Series     Correctly charges motorcycle Lead Acid Series batteries - Standand & Heavy Duty Flood Cell, AGM VRLA and...

Air Pressure Sensor 1 bar (Laverda)

Air Pressure Sensor 100kPa (1bar)

Air Pressure Sensor 82051 Ignitech. Range to 1.2 bar

Pressure Sensor 82051. A suitable addition to the Ignitech TCIP4 when fitted to replace Digiplex ignition Modules e.g. Ducati. The counterpart connector is supplied. Air Pressure Range 1.2 bar

Air Pressure sensor IAPS120 Ignitech. Range to 1.2 bar

Pressure Sensor IAPS1200.  Combined air pressuse and temperature sensor. Range to 1.2 Bar.  The counterpart connector is supplied.

Air Pressure sensor IAPS250 Ignitech. Range to 2.5 bar

Pressure Sensor IAPS250.  Combined air pressuse and temperature sensor. Range to 2,5 Bar.  The counterpart connector is supplied.

Air Pressure sensor IAPS300 Ignitech. Range to 3.0 bar

Pressure Sensor IAPS1200.  Combined air pressuse and temperature sensor. Range to 3.0 Bar.  The counterpart connector is supplied.

Air Temperature Sensor (LV071003000003)

Alternator Generator (race) 12V miniature Ø75x46mm 150W

Alton 12 volt A.C. generator with a diameter of only 76mm. While running at moderate cruising speeds this tiny alternator supplies an output of 85 to 90 watts (maximum output of 150 watts). It will...

Alternator Rotor Magnets Laverda 1000/1200 S1 (New)

Magnetic rotor for alternator on Series 1 Laverda 1000/1200 models 1973-81. Does not include the Flange

Alternator Rotor Magnets Laverda 1000/1200 S1 (Used)

Magnetic rotor for alternator on Series 1 Laverda 1000/1200 models 1973-81. Does not include the Flange

Banjo Bolt Single Brake Pressure Switch M10x1.0 (spanner size 17mm)

Thread M10x1.0 suits Brembo and most European models. Product image for illustration purposes only.

Banjo Bolt Single Brake Pressure Switch M10x1.0 (spanner size 22mm)

Brake Switch used on the rear brake of Laverda and many other motorcycles. It requires a 22mm spanner for tightening and is the correct size to suit the Rubber Brake Switch Cover You may also need...

Battery Cable Earth Strap Braided Copper (71103013)

Ground (-) Earth Wire Braid from Battery to Chassis on Laverda 500, 750, 1000, 1200 models. Length 180mm Width   20mm Hole size for M6 For cable type earth wire fitted with heavy duty crimped M6...

Battery Charger NOCO Genius 1 1Amp 6/12v/Li/Lead with quick connect

NOCO Genius 1 UltraSafe Smart Battery Charger & Maintainer for 6V & 12V Lead Acid Series and 12.8V Lithium [LiFePO4] Batteries. Correctly charges Lead-Acid/AGM/GEL Series batteries up to 30Ah with...

BATTERY Dynavolt (AGM) 12V 20Ah 400cca MG20HL-BS-C (L175xW87xH155)

IMPORTANT - Batteries by Road Only. Batteries of any type can no longer be air-freighted - No Exceptions Sealed Factory Activated AGM GEL Lead Acid Battery.No messing around with battery acid -...

BATTERY Dynavolt (AGM) 12V 21Ah 340cca MG52113 (L183xW79xH171)

CYK57-521-13 IMPORTANT - Batteries by Road Only. Batteries of any type can no longer be air-freighted - No Exceptions SUITS: Laverda 1977-1985 350/500, 750 SF1-3, and Zane Laverda 650,668,750S...