Programmable ignition for 1974 Suzuki 750 GT water cooled two stroke. Replaces breaker points system.

SET Includes:

• 1 x DCCCDIP4 with pre-programmed ignition curve for Suzuki 750 GT
• 1 x Loose wire connector loom
• 1 x Base Plate
• 1 x Rotor (shown in the photo at 10° BTDC)
• 1 x Pickup IP6

This unit requires a 12 V DC battery and Ignitech Coil IC-CDI-S. (It will not operate using the original coils)

Recommended accessories:

USB-Com Cable to connect to PC Computer

Com-Com Cable extension 5metres

This Ignitec SPARKER DCCDIP4 ignition is equipped with 4 x inputs for pickup. Suitable for 4 cylinder, 120 Degree 3, and 6 cylinders engines or where more than two inputs is desirable.

Input for throttle position sensor or inlet air pressure sensor, two multifunctional switch inputs for blocking, kill switch, retard etc. output for tachometer, two multifunction switch outputs for fuel pump relay, gear shift light etc

This Ignition is fully programmable using Computer Software. Software control includes advance map or curve, options for blocking, rev limiter etc.

A free download is available for the DCCDIP4 Owners Manual

5K Ohm Resistor plug caps or 'R' type spark plugs (but not both together) are required to avoid damage to the Ignition unit.